|
STEP-BY-STEP
INSTRUCTIONS FOR ROD INSTALLATION
STEP
1: 
1.
MAKE SURE THE GUN IS SAFE.
2. REMOVE THE SLIDE FROM THE FRAME.
3. REMOVE THE STOCK GLOCK®
RECOIL ROD.
STEP
2: 
INSTALL
THE BUFFER TECHNOLOGIES GK1 BUFFER IN THE NOSE OF THE SLIDE -
(YOU CANNOT MAKE A MISTAKE - THE ONLY WAY IT WILL FIT IS WITH
THE EARS AGAINST THE SLIDE RAILS AND THE ROUND PART FACING UP).
STEP
3: 
1.
PLACE YOUR DEAD BANG RECOIL ROD INTO THE SMALL
END OF THE WOLF SPRING.
2. PLACE THE ASSEMBLED ROD/SPRING INTO THE GK1 BUFFER AND INSTALL
BACK ONTO THE BARREL.
**Buffer
Tech buffer shown only for reference purposes only
HELPFUL
HINT FOR FULL-SIZE GLOCKS: UNTIL YOUR SPRING BREAKS IN
(AFTER ABOUT 50-100 CYCLINGS), KEEP THE SPRING PARALLEL TO THE
BARREL AS CLOSE AS POSSIBLE AND WALK THE ROD THROUGH THE SPRING
UNTIL IT GOES THROUGH THE HOLE IN THE SLIDE. IT WILL BE A LITTLE
STIFF AND UNTIL THE SPRING BREAKS IN AND YOU BECOME PROFICIENT
YOU WILL NEED A LITTLE PATIENCE.
YOU
ARE DONE!
PLACE THE SLIDE BACK ON THE FRAME AND ENJOY THE REDUCED RECOIL
REDUCTION OF YOUR "NEW GUN".
back
to top
|
